Elipta Modula Recessed Uplight - Brass - Round - 240v GU10
5 in stock
- Product Overview
- Downloads
- Reviews
The Elipta Modula (brass) is a stylish 240v recessed uplight which takes a choice of 240v 3w - 8w LED lamps. LED lamps also result in a much lower lens temperature, which is important in walkover areas. This garden light is fitted with a flush lens as standard. The light is located by an "O" ring on the body into a sleeve tube. To help with the removal of screws for future relamping or other maintenance, apply copper grease to the threads of all screws being fitted for retention of bezels, grills or other top plates or retaining rings.
Copper grease resists degradation due to heat and protects against difficulty in removing screws, particularly where stainless steel screws are fitted with aluminium parts. It may also be used on screw threads of screw-off bezels or glare shields. Ensure surplus is cleaned off with a solvent to prevent staining in use.
| Colour/Finish: | Fine sandblasted cast brass finish looks good on decking, timber, sandstone and buff brick |
|---|---|
| IP Rating: | IP67 |
| Construction: |
Front bezel is attached to tubular aluminium body. 2m cable via rear entry cable gland |
| Input Voltage: | 240v |
| Lamp Type: | 240v GU10 long-life energy-saving compact fluorescent and 3w or 5w l.e.d. lamps; 50,000 life and low energy consumption make these a popular option. led and fluorescent lamps also result in a much lower lens temperature, which is important in walkover areas. |
| Installation: |
The plastic sleeve is built in during construction or retrofitted into a hole cut with a coring bit: the light pushes into the tube, where it is held firmly in place by an o-ring. Using a single RCD for large numbers of 240v fittings is not recommended due to the risk of nuisance tripping. We advise the use of separate RCD protection for each circuit and a maximum of 12 fittings per RCD. Where a garden lighting installation of more than 12 spike mount or recessed lights per circuit is proposed, we suggest the installation of 12v units with transformers, which results in a significantly higher fault tolerance and reliability in the total installation |
| Accessories: |