Elipta Micro Waymarker LED Recessed Light 90° -12/24v DC-3w-100lm-2700K-IP67- 316 Stainless Steel
Out of stock
- Product Overview
- Downloads
- Reviews
The Elipta Micro Waymarker 90 recessed LED light is compatible with both 12v and 24v DC power supplies. 90° light output comes from a single window and it is useful where you want to cast light across a path or drive edge without casting light backwards onto planting or other finishes behind. The Micro Waymarker is an outdoor LED light with a flush glass lens, fitted to the top of the dome, preventing debris from settling and blocking the light output. The light is located by an "O" ring on the body into a sleeve tube so that external screw fixings are hidden. This garden light may also be used as a deck light. We recommend using a 12v constant voltage dc power supply for optimum performance, which can be purchased separately.
| Colour/Finish: | Smart 316 grade stainless steel is a popular choice for modern garden settings |
|---|---|
| IP Rating: | IP67 |
| Construction: | Stainless steel top plate is attached to an anodised aluminium body which push fits into the anodised aluminium tube, where it is held firmly in place by an o-ring, leaving a front plate with no visible fixing screws. 1.5m cable via rear entry cable |
| Input Voltage: | 12v / 24v DC |
| Wattage: | 3w |
| Light Output: | 100lm |
| Beam Angle: | 90° |
| Colour Temp: | 2700K warm white |
| Life Span: | Approximately 50,000 hours |
| Installation: |
The aluminium sleeve is built into the floor/paving during construction or retrofitted into a hole cut with a coring bit: The light pushes into the tube, where it is held firmly in place by an o-ring, leaving a front plate with no visible fixing screws. Suitable drainage should be provided below each fitting to prevent water logging. Micro Waymarkers should not be installed in ground subject to water logging. Connect input cable to cable from an LED power supply using T9962 cable joint or T9963 cable splice kit or T9969 underground joint kit |